| Make yourself comfortable now with Heated Seats!!
The
Seat Heater elements are paper-thin, and install between the seat cover
material and the seat cushion. They are fully water-resistant and pose
NO problem with damp winter cloths, spilled beverages, or wet pets!
They are NOT visible and do not detract from the finish or look of your
vehicle`s factory upholstery.
A small
three-position switch (off, low, high) is installed in the lower seat
trim panel for a "factory" type appearance. All wiring and the heat
element controller are concealed below the seat or run under the door
sill trim plate, carpeting, etc. It is fully compatible with existing
power seats or multi-adjustable "sport" type seats finished in cloth,
vinyl, or leather.
You will need a power source
that turns on/off with the ignition switch, if your car seats are
electric you already have a power source (check if it works with
ignition switch, otherwise you will have to run a wire to the fuse box)
under your seat for these seat heaters and it comes with a 24" (600mm)
Power Lead to splice into the Seat Harness. The advantages of This Seat Heater
- Consistent and controlled warmth (up to 110 degrees) with carbon technology.
- Heating level is adjustable to suit personal requirement.
- Element can be trimmed to fit any seat (without side Airbags).
- Single seat application possible. The aftermarket heater with original equipment specifications.
- The seat heater system gives you all the features and quality you would expect from an original equipment installation.
- The application of carbon technology ensures the even spread of warming to both the seat back and the cushion. Feel comfortable in minutes.
- High quality materials guarantee reliability and long life.
- Elegant switch with fingertip control.
- The heat can be adjusted to two levels to suit your needs.
 SWITCHES & HARNESSES The Heater kit comes with the following switch;
- HIGH/OFF/LOW
- "Hi" setting: 104 - 108 degree (+/- 4 degrees).
- "Lo" setting: 98 - 102 degree (+/- 4 degrees). HEATER ELEMENTS
- Type: Carbon Fiber / Felt Panels
- Each panel 10" (266mm) X 20" (500) - 104 Degree F (40C)
- Element can be trimmed to the desired Length or altered to accommodate plastic seat.
- Power: 12V / 4.7 Amp/60W Heat
- 24" (600mm) Power Leads to Seat Harness
Warranty: Manufacturers One Year / 12,000 miles on parts only. Universal fit, Sold individually for each seat, order 2 for 2 seats or the 2 seat kit (CD-DSD-03A) sold below. Will not fit vehicles with Seat Side Airbags Optional
Pair Seat Relay Harness Powers two seats. One connection obtains power
from a battery source and is ingnition switch activated. Independent
control of each seat heater is maintained. KIT COMES WITH
INSTALLATION INSTRUCTIONS & PLUG & PLAY PRE-WIRED HARNESS,
SWITCH & RELAY, YOU JUST NEED TO SUPPLY ONE 12 VOLT DC SOURCE THAT
GOES AND OFF WITH IGNITION
|
Code: CD-SSD-03A
