Peak 11" x 11" Dual Pad Universal Carbon Fiber Seat Heater Kit

This Seat Heater Kit consists of 2 elements (1 for the back and 1 for the bottom) and an illuminated hi/lo/off round 3/4" switch.

The 2 heating elements can be controlled for your personal comfort using the switch.

Kit can be installed in any seat with a 12 Volt source. Pads must be installed under the seat cover, whether cloth, vinyl or Leather. 2 Wire Hookup. Red goes to a 15-20 Amp fused 12 Volt Positive (must go on/off with ignition switch) and White goes to Ground.

High Temperature is 131°F and Low Temperature is 109°F. Current Draw is 4 Amps on Hi & 1.5 Amps on Lo

Kit Contains;

2 Carbon Fiber Element (instead of copper wire) pads, 11" wide x 11" long and is as thick as 4 pieces of regular printer paper.

Length can be cut down to 4" and width can be trimmed to 91/4" by scissor.

You can cut holes inside the pad and it will not effect the rest of the pad.

Each Pad has 2 strips of double stick tape to keep the pad in place while re-installing the seat cover (paper tape cover must be removed prior to installation)

Power and Switch Harness (pre-wired)

Illuminated round Hi/Lo/off switch (pre-wired)

Everything plugs into each other

Wire ties

1 Year Limited Warranty